Copper Talk » Modifications » Radios » Mods for the EPT0696 10Z main board « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Starlighter
Posted on Monday, January 28, 2002 - 1:46 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Hi 307,

I have done the freq. and clarifier mods on my TR696F-SSB but would like to know how to do the 10 KHZ jump switch mod.I can use an external switch like I did for the channels or the NB switch on the front panel.I just need to know what to hook the wires to. I am familiar with the method used for the EPT 6000 10z board but can't find the same jumpers on this one. Thanks,Starlighter
Top of pagePrevious messageNext messageBottom of page Link to this message

Tekdummie
Posted on Sunday, February 23, 2003 - 2:26 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Galaxy DX Radios DX959
Documentation Project
10kc Mod


Changing the logic level of pin 16 on the RCI 8719 PLL chip will give you a +10kc or -10kc depending on channel selector. Cut the trace at pin 16 as shown and bridge the cut with a 4.7K ohm resistor. You can then wire the center contact of a spdt on-off-on switch to the PLL pin side of the 4.7K resistor Pin16. Wire one outside contact of the switch to Pin 9 for 8 volts and the other outside contact to Pin 18 for board ground.

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: