| Author |
Message |
    
Liz
| | Posted on Monday, November 10, 2003 - 6:50 pm: | 
|
I have an alliance HD73 rotor and going to put a beam on it and was wondering If anyone has a owners book or can give me any information on the rotor, such as voltages,rotor plate size ect. Any and all help would be appreciated |
Scrapiron63
| | Posted on Monday, November 10, 2003 - 8:13 pm: |
|
I use the HD73, great rotor. The bolt pattern is different than the CDE and other rotors so you'll have to drill new holes if you have one of the rohn rotor plates. I've got the owners book somewhere, but doubt if it gives much information. You can measure the bolt pattern from the bottom of the rotor. Scrapiron |
Dx431
| | Posted on Tuesday, November 11, 2003 - 1:49 am: |
|
Liz, I sent you an email with some info......
431 |
Scrapiron63
| | Posted on Tuesday, November 11, 2003 - 5:16 pm: |
|
Well I did find the owner's manual today. Here's a few things about the HD73.
It has 200 ball bearings.
It's good for 10.7 square feet of wind load.
Motor runs on 20 volts AC.
Bolt pattern is 3 5/16 inches on center.
Needs 6 conductor wires, 20 gauge wire is good for up to 125 feet.
It has two speed control box, top speed is 1 rpm.
This manual has a complete parts list if you need anything else. They are nice rotators, I found this one new in the box a couple years ago at an auction. Got it at a bargain. scrapiron |
Dx431
| | Posted on Friday, November 14, 2003 - 11:32 pm: |
|
Liz, I sent you another email......the first one I sent, came back......
431 |
|
