Author |
Message |
Boxcar
Intermediate Member Username: Boxcar
Post Number: 272 Registered: 4-2002
| Posted on Tuesday, April 13, 2004 - 9:18 pm: |
|
Does anyone know the color wiring code for a stock rci 2950 mic? Blue--RX, Red-->TX etc!! I have finally found my stock mic for my 2950 and I forgot I snipped the plug clean off. Thanks!!
|
Wf805
New member Username: Wf805
Post Number: 9 Registered: 2-2004
| Posted on Tuesday, April 13, 2004 - 10:40 pm: |
|
1. Ground Shield 2. Audio Yellow 3. Transmit Red 4. Receive Black 5. CH. Up White 6. CH. Down Blue
|
Boxcar
Intermediate Member Username: Boxcar
Post Number: 272 Registered: 4-2002
| Posted on Wednesday, April 14, 2004 - 4:13 pm: |
|
Thanks Wf805!!!!! |
Nitemare
Junior Member Username: Nitemare
Post Number: 21 Registered: 8-2003
| Posted on Wednesday, April 14, 2004 - 10:29 pm: |
|
Need color code for wiring CDL over drive mic to a 6 pin to use on my new 2970 |
Tech808
Moderator Username: Tech808
Post Number: 2141 Registered: 8-2002
| Posted on Wednesday, April 14, 2004 - 11:27 pm: |
|
Nitemare The Overdrive CDL-56K should be wired: Pin #1 ~ SHIELD PIN #2 ~ AUDIO PIN #3 ~ TRANSMIT PIN #4 ~ RECEIVE Tha same wires on the Overdrive CDL-56K 4 PIN Mic Connector go to the SAME Pins on the 6 PIN Mic Connector for the Ranger. PIN #1 ~ SHIELD PIN #2 ~ AUDIO PIN #3 ~ TRANSMIT PIN #4 ~ RECEIVE PIN #5 ~ N/C = NO WIRES PIN #6 ~ N/C = NO WIRES Be sure to write the WIRE COLORS on each Pin down before Disconnecting them from the OVERDRIVE CDL-56K Mic. Hope this help's. Lon Tech808 |