| Author |
Message |
    
Power_pusher
New member
Username: Power_pusher
Post Number: 1
Registered: 7-2004
| | Posted on Wednesday, August 11, 2004 - 5:09 pm: | 
|
Does anyone know the tune up and clip for this radio? thanks in advance. |
Bc910
Junior Member
Username: Bc910
Post Number: 27
Registered: 7-2004
| | Posted on Wednesday, August 11, 2004 - 7:55 pm: |
|
DONT CLIP!!!!!!
Try radiomods.co.nz
but trust me DONT CLICK!
BC |
Bc910
Junior Member
Username: Bc910
Post Number: 29
Registered: 7-2004
| | Posted on Wednesday, August 11, 2004 - 10:36 pm: |
|
Sorry let me re-state that for two reasons
1: It was rude!
2: I meant to say "but trust me DON'T CLIP!"
So here goes:
When you clip the audio limiter in any radio all it does is make over-modulation and adjacent channel splatter! Both of which are very bad things, you want to be loud right? If you want loud and proud, not obnoxious and rude then get yourself a digital signal processor for your radio. This mod will make you so loud people will have to turn down their radios! On the other hand you will be crystal clear and "BOOMIN'" I'm not sure if copper sells them or not, I haven't seen them, but what does that mean there is a lot of things here I'm sure I haven't seen yet. The other thing you can do is CHANGE the limiter I know people do it and it seems to work well, but I never have so I don't know. One more thing, I looked around on the internet and couldn't find any mods on the 78, too bad you don't have the 76 (I think it may be the same except the back light but I'm not sure).
Good luck
BC
|
Brewdirect
Junior Member
Username: Brewdirect
Post Number: 22
Registered: 7-2004
| | Posted on Wednesday, August 11, 2004 - 10:39 pm: |
|
For that radio...you'll want to turn up the modulation pot VR4 (I think) and then if you still want more modulation you can try the super mod modification.
|
Tech808
Moderator
Username: Tech808
Post Number: 3279
Registered: 8-2002
| | Posted on Wednesday, August 11, 2004 - 11:53 pm: |
|
Power pusher,
WELCOME TO THE COPPER FORUM!
Modulation: Adjust VR-4
Power: Adjust: L14, L13, L12
Hope this helps.
Lon
Tech808 |
