| Author |
Message |
    
Mrgoody
Junior Member
Username: Mrgoody
Post Number: 41
Registered: 1-2005
| | Posted on Thursday, August 09, 2007 - 12:11 pm: | 
|
I have a Italy 200p stinger board that I'm installing on a cobra 148gtl (newer type)...and would like to know an appropriate place where I should ground the sheild wire's and is it ok to ground both wire's in the same place. |
Mrgoody
Junior Member
Username: Mrgoody
Post Number: 42
Registered: 1-2005
| | Posted on Thursday, August 09, 2007 - 9:44 pm: |
|
need help here |
Tech808
Moderator
Username: Tech808
Post Number: 14227
Registered: 8-2002
| | Posted on Thursday, August 09, 2007 - 10:08 pm: |
|
BOTH of the Shields on the RTX Coax & ANT Coax from the board MUST be GROUNDED to the CHASSIS per Installation Instructions!
Hope this help's,
Lon ~ Tech808 ~ N9CEF
CEF#808 ~ CEF HAM#33 ~ CVC#002
Tech808@copperelectronics.com
|
Mrgoody
Junior Member
Username: Mrgoody
Post Number: 43
Registered: 1-2005
| | Posted on Friday, August 10, 2007 - 10:02 pm: |
|
Hey Lon;How it going...long time...would grounding the two shield's to the back screw hole be suffitiant enough..? |
Hotwire
Senior Member
Username: Hotwire
Post Number: 2391
Registered: 1-2005
| | Posted on Tuesday, September 04, 2007 - 12:24 pm: |
|
Mrgoody, That is what I did and it worked just fine.73
KEEP IT REAL!
Kenny
cef491(27.115lsb)
2sf491(27.555usb)
Indiana
|
