| Author |
Message |
    
Linx
Intermediate Member
Username: Linx
Post Number: 107
Registered: 9-2006
| | Posted on Friday, November 23, 2007 - 9:33 am: | 
|
Hi there,
I'm working on my brother in laws little Cobra 25 LTD Classic. It has a final out, so I replaced it with a mosfet, but the radio now has another problem I can't seem to fix. The Noise Blanketer is not working. The switch says "NB and OFF" and it does not do anything. Any clue what I can look for inside the radio to fix this problem, or get me off to a good start? Thanks
Rob
CEF# 830
Portland, TN
|
Linx
Intermediate Member
Username: Linx
Post Number: 108
Registered: 9-2006
| | Posted on Saturday, November 24, 2007 - 2:50 pm: |
|
Anyone? Anyone?
Rob
CEF# 830
Portland, TN
|
Tech808
Moderator
Username: Tech808
Post Number: 14723
Registered: 8-2002
| | Posted on Saturday, November 24, 2007 - 3:38 pm: |
|
Here are a couple of suggestions to try.
#1 ~ With 12V power disconnected from the radio get a Volt/Ohm meter and check the switch to make sure it is working (ON) allowing continuity thru the switch and (Off) allowing No continuity thru the switch.
#2 ~ Check the wires to the switch and make sure they have good connections to the switch and one of them did not come loose.
#3 ~ Then make sure that one of the wires did not become dis-connected from the board when you were doing the other modifications.
Hope this help's,
Lon ~ Tech808 ~ N9CEF
CEF#808 ~ CEF HAM#001 ~ CVC#002
Tech808@copperelectronics.com
|
|
