| Author |
Message |
    
Lonestarbandit
Member
Username: Lonestarbandit
Post Number: 94
Registered: 10-2006
| | Posted on Friday, April 04, 2008 - 4:22 pm: | 
|
help! need to know the mic wiring for panasonic 5 pine din from the 80s please! if anyone rembers those pannys with the dual vertical meters... |
Hyperno_1979
Advanced Member
Username: Hyperno_1979
Post Number: 731
Registered: 12-2005
| | Posted on Saturday, August 30, 2008 - 6:50 am: |
|
DIN stands for Deutches Institut fur Normung which loosely translates to German Institute for Standardisation. It was an attempt to standardise a whole lot of things which basically didn't take off too well. Electronics, hydraulics, etc. So in saying that...wiring for Realistic, Panasonic, or any radio that runs DIN plugs should wire up the same. I hope.
CEFFFCEF
Bob
CEF703/CVC26
703 New South Wales
|
Hyperno_1979
Advanced Member
Username: Hyperno_1979
Post Number: 732
Registered: 12-2005
| | Posted on Saturday, August 30, 2008 - 7:02 am: |
|
Ok upon further investigation Jason i have found a few discrepancies on DIN wiring. Check this out it might be more helpful.
http://www.grozzer.freeuk.com/info17.html#CB%20Tranciever%204.
CEFFFCEF
Bob
CEF703/CVC26
703 New South Wales
|
