| Author |
Message |
    
Kingkong
New member
Username: Kingkong
Post Number: 1
Registered: 6-2009
| | Posted on Wednesday, December 09, 2009 - 6:48 pm: | 
|
help!
I copied a mod done to my friends, it removed r15 and added v+ to the removed spot. also removed tx offset pot.
I cant find any info on the" jumper" points to be worked on. radio slides ok but cuts out on end. I just want to see the correct way to do this thanks
chris |
Tech808
Moderator
Username: Tech808
Post Number: 17278
Registered: 8-2002
| | Posted on Thursday, December 10, 2009 - 6:28 am: |
|
Kingkong,
1st off Welcome to the Copper Forum!
Now for your Question:
From my notes I found:
Remove the rear cover.
Find a small PCB that has the PTT and UP/DOWN switche's mounted on it.
Then on the back side of this small / littel PCB you should find a small group of 3 small solder islands that end on the outside edge of the board.
Solder a jumper across all 3 islands.
Hope this help's,
Lon~Tech808
N9CEF
CEF#808~CVC#002
Radio Enthusiast!
|
|
