Copper Talk » Ask The Tech » Modifications » Ranger 6900F150

« Previous Next »

Author Message   Timenxs Junior Member Username: Timenxs Post Number: 18 Registered: 6-2011 Posted on Thursday, January 26, 2012 - 12:03 pm:        I have a Ranger 6900F150. The coarse RIT is very touchy when trying to zero in the transmit frequency. I was wondering if there is any way to make these less touchy. In other words take more of a turn to move the frequency. At this point it is very hard to zero in on the center of a channel. I was thinking a lower value resistor would do the trick but figured it would affect the amount of swing in frequency it had. Any ideas? Thanks   Dale Senior Member Username: Dale Post Number: 1816 Registered: 12-2002 Posted on Thursday, February 02, 2012 - 11:35 am:        if your radio is tuned properly the tx freq. shopuld be right on or very close. if not id have it setup correctly then all ya gotta do is just use the fine control and its nowhere near as touchy.but if ya get luck and find where it needs to be, to get on freq. then id leave it alone and never touch it again an d just use the fine control. if not you,ll be always chasing it down. dale/a.k.a.hotrod cef426 cvc#64

Add Your Message Here Post: Username: Posting Information: This is a private posting area. Only registered users and moderators may post messages here. Password: Options: Enable HTML code in message Automatically activate URLs in message Action: