Copper Talk » Ask The Tech » Modifications » Modulation on a Midland 77-285A « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Sintronic_Cpu
Posted on Sunday, March 03, 2002 - 6:00 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
I did the power mods and peaked the board best I could do with the info I can find for it, there aren't very many adjustments to even peak anyhow, but no matter where I set the carrier, the modulation won't even get to 65% with a good power mike, only about 50% with the stock mike....any suggestions?
Top of pagePrevious messageNext messageBottom of page Link to this message

307
Posted on Sunday, March 03, 2002 - 9:27 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Modulation Limiter may be defeated buy cutting the land pattern from the electrolytic Cap C162 to the surface mounted transistor marked with "ASG" on its surface. DO NOT REMOVE THE TRANSISTOR.

307
Top of pagePrevious messageNext messageBottom of page Link to this message

Sintronic_Cpu
Posted on Monday, March 04, 2002 - 4:48 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
I did that already, only helped a few percent, not a very nominal difference :(
Top of pagePrevious messageNext messageBottom of page Link to this message

Sintronic_Cpu
Posted on Thursday, March 14, 2002 - 11:11 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Is there anything else I can do to it at all??? :(:(:(

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: