| Author |
Message |
    
Scrapiron63
| | Posted on Tuesday, December 10, 2002 - 10:26 pm: | 
|
Anyone know where I might find a set of relays for an old Pride DX 300. Thanks, scrapiron |
Jp1116
| | Posted on Friday, December 13, 2002 - 11:52 am: |
|
I know where you can get the 2PDT pre-amp relay. I need the 4PDT myself and have a sub but didn't try it yet. I'll look it over tonight and see if it is the same or not. If I forget to let you know, email me at jp1116@netzero.net |
Scrapiron63
| | Posted on Friday, December 13, 2002 - 6:40 pm: |
|
The 4PDT is what I need, thanks and please let me know. scrapiron |
Jp1116
| | Posted on Saturday, December 14, 2002 - 5:52 pm: |
|
The 4PDT relays out of the Palomars do work. I will try to cross them to a current part number. |
Jp1116
| | Posted on Saturday, December 14, 2002 - 10:55 pm: |
|
I did some checking and the R10-E1W4-V185 relay has higher rated contacts than the ones used in Palomars. You might want to just order one of those. |
Kc8pcl
New member
Username: Kc8pcl
Post Number: 1
Registered: 7-2011
| | Posted on Monday, July 18, 2011 - 7:30 pm: |
|
I am looking to find information about the low power board in my Pride DX 300. I must have an older version because the only info I can find about this does not show the board that is in my amp, the parts are not in the same position as shown on cbtricks or any other place I have looked, can anyone help me here? I could use a schematic or even some pictures. Thanks |
238
New member
Username: 238
Post Number: 1
Registered: 1-2006
| | Posted on Friday, September 09, 2011 - 11:14 pm: |
|
Yours LP board sounds like the one in mine. It has fewer parts on it. Never found any info on it. Got a new board from RF Parts. 238 |
