| Author |
Message |
    
Buck
| | Posted on Thursday, June 26, 2003 - 9:01 pm: | 
|
Here is one for you Lon....I would like to put a 4 pin connector on my 148 instead of the 5 pin. All my other radios are 4 pin and would like to be able to interchange them...Any help??
Thanks
Buck |
Tech808
| | Posted on Thursday, June 26, 2003 - 10:35 pm: |
|
Buck,
My suggestion would be to get a Mic Adapter from 4 Pin Cobra to 5 Pin Cobra. Only $3.99 from Copper and a WHOLE lot easier than re-wiring.
Check the Link below.
http://www.copperelectronics.com/cgi-bin/checkitout/checkitout.cgi?catalogSTORE:CKIE:prodM60-07428+
And then you will have it on hand for future use as I am sure you will pick up more radios over the years that you could use it on.
Actually I have the Whole Set and makes it very easy for working on different radios and for testing all Mics.
Just my thought's
Lon
Tech808  |
Buck
| | Posted on Friday, June 27, 2003 - 8:10 am: |
|
Thanks Lon..I knew you could figure that one out  I think I will call copper today
Buck |
Tech808
| | Posted on Friday, June 27, 2003 - 8:29 am: |
|
Buck,
Glad I could make an Easy suggestion.
These little critters really save a person a lot of time and allows to to try about every kind of mic out there on any radio you have or might get without re-wiring them.
When you call say Tech808 told you to call and you want to buy a dozen of each. 
Have a good weekend!
Lon
Tech808 |
Buck
| | Posted on Friday, June 27, 2003 - 6:19 pm: |
|
Dozen of each and put them on Lons tab???? Sure thing |
Gunship
| | Posted on Friday, August 15, 2003 - 11:21 am: |
|
If you ever decide to hardwire it, just put the switch(Or Common) wire on the same pin as the shield on both the mike plud and the bulkhead. |
|
