| Author |
Message |
    
Radiodude
| | Posted on Sunday, December 07, 2003 - 11:09 pm: | 
|
I have a Echo Max 2000 mic hooked up to my 2995dx. With the roger beep off on the radio and on , on the mic the radio skips up a channel when I key the mic. When it is off on the mic and on ,on the radio it doesnt do this
Any ideas?? |
Topten
| | Posted on Monday, December 08, 2003 - 7:23 pm: |
|
Hi RD,
Somehow the mic must be sending the radio a small stray voltage spike, and the radio interpets that as a channel up command. Check out the mic plug soldering job, it could be shorting out a pin. Hope that helps.
BTW, Hope your healing well.
73's |
Marlboro_Man
| | Posted on Monday, December 08, 2003 - 7:30 pm: |
|
I don't have a clue what would cause that but I run a 2990dx with a Sadelta echo master plus mic and when i only run the single tone beep in the radio it does fine. When I only run the dual tone beep in the mic it also does fine. But when I run both of them either the radio beep cancels out or the last tone on the mic cancels out. Just swaps out!! |
Tech808
| | Posted on Monday, December 08, 2003 - 8:20 pm: |
|
Radiodude,
Check the Mic Plug and make sure Nothing is Touching or Shorting out,
Mic
Pin #5 Channel DOWN or
Pin #6 Channel UP
BOTH PINS SHOULD BE OPEN / NO CONNECTONS
If these are ok then the problem is with the Echo Max 2000 not the radio.
Hope this help's
Lon
Tech808 |
Radiodude
| | Posted on Tuesday, December 09, 2003 - 7:25 pm: |
|
Tnx all I will check it out!!
OBTW I am much better and doing good. |
|
