| Author |
Message |
    
Jake
| | Posted on Thursday, January 15, 2004 - 9:39 pm: | 
|
The radio receives fine,oh and all systems work except output. you can see that the radio keys up and the meter moves try and modulate and nothing happens, still,no output in any mode.Can someone pls HELP. Thanks Jake |
Bigbob
| | Posted on Thursday, January 15, 2004 - 11:06 pm: |
|
I had an eagle 2000 and the mike pre-amp blew out and it did just what you say,a tech replaced it and I was back in business.Bigbob |
Crafter
| | Posted on Friday, January 16, 2004 - 5:55 pm: |
|
Jake what kind of radio is it? Does the PA mode work if it has one. |
Damyankee
| | Posted on Friday, January 16, 2004 - 7:55 pm: |
|
Guys,
He filled in the blank on the "Pay attention..." post in this thread. Don't know if my suggestion worked or not??? |
Jake
| | Posted on Sunday, January 18, 2004 - 10:40 am: |
|
Thanks for the help Guys, and Damyankee It's not in the PA mode the pa doesn't work when in the pa mode you can hear as if you were in the regular receive mode without a lot of volume and it sounds like it doesnt key up.Oh and some more INFO I've replaced both finals,driver,voltage reg,audio chip and still no watts out, and It's a Galaxy Saturn. Again thanks Guys. Jake |
Tech8541
| | Posted on Sunday, January 18, 2004 - 6:40 pm: |
|
what radio is this?? |
Tech8541
| | Posted on Sunday, January 18, 2004 - 6:45 pm: |
|
nevermind, i see it now....i'll get back to after the game. the fatman (ruban studdard) is singing the anthem now, so 'showtime' is very close. |
307
| | Posted on Sunday, January 18, 2004 - 7:11 pm: |
|
If I had to guess , I would say it is the Pre-Driver or Final. When you say it "tries" to key up , do you have "ANY" power on you external power meter?
307 |
Tech8541
| | Posted on Tuesday, January 20, 2004 - 10:14 pm: |
|
i tend to think that the everything up to the final is fine. i think this because you say that the meter goes over when you key. if that is the case, then there has to be power going out. and it must be making it to the output power detector or else the meter would not be moving. so you have a small area after between the power detection branch off and the antenna port where the power is being lost. this usually comes from a cold solder connection.
but...can you make it clear...is the power meter moving over when you key? from you wrote above, it sounds that way, but i want to make sure that i read correctly. |
|
