| Author |
Message |
    
Qper
| | Posted on Monday, December 24, 2001 - 6:14 pm: | 
|
Hi I have a Texas Ranger 6900F JUMBO and a new style Connex 4800DXL, the one with echo. I want to tie together the transmit and receive on the clarifier. I've done it on other radios. I can't find the mod anywhere though. If anyone could help me out I'd appreciate it. 73'S QPER 222 |
Qper
| | Posted on Monday, December 31, 2001 - 5:40 pm: |
|
All set figured it out on my own |
Wareagle
Junior Member
Username: Wareagle
Post Number: 36
Registered: 12-2001
| | Posted on Thursday, March 25, 2004 - 10:06 pm: |
|
same mod as for Cobra 148 gtl dx |
Kc0gxz
Advanced Member
Username: Kc0gxz
Post Number: 685
Registered: 3-2003
| | Posted on Monday, March 29, 2004 - 1:26 pm: |
|
Wareagle
Sharing the clarifier mods with other Copper members would be nice.
Jeff, kc0gxz. |
Jon666
Intermediate Member
Username: Jon666
Post Number: 206
Registered: 11-2003
| | Posted on Friday, May 21, 2004 - 6:33 pm: |
|
shure would
i looked all over cant find anything anyware
on the clarifer would like to do mine
thanks
jon |
Tech808
Moderator
Username: Tech808
Post Number: 2443
Registered: 8-2002
| | Posted on Friday, May 21, 2004 - 7:33 pm: |
|
Jon,
In the above post from Wareagle he said it was the same for the Cobra 148 GTL-DX.
Not sure if this is correct as it is for the OLDER 148 GTL-DX.
Clarifier Modification:
#1 ~ Remove D84
#2 ~ Remove the Blue wire from the FINE Tune control and PC board.
#3 ~ Run a New wire from from where the Blue wire was on the Fine Clarifier control to cathode of D-88 (located directly in front of Green A-473 Power Transistor on right side of Chassis.)
#4 ~ For more "Down Slide" pull OUT R-232 and install a wire jumper in it's place. This will give you about 12KC down slide.
NOTE!
If you like the FINE CLARIFIER SKIP step's 1 ~ 3.
Hope this help's.
Lon
Tech808 |
Jon666
Intermediate Member
Username: Jon666
Post Number: 207
Registered: 11-2003
| | Posted on Friday, May 21, 2004 - 8:33 pm: |
|
thanks lon |
Ab5az
New member
Username: Ab5az
Post Number: 4
Registered: 5-2004
| | Posted on Tuesday, May 25, 2004 - 10:36 pm: |
|
Qper, Connex 4800 DXL and all RCI 6900 *** " C " boards. Remove D68. Remove R 113. Add a jumper from the " Right side " of R 113 to 8 volts. I will attempt to upload a .jpg showing the jumper, although I ran the jumper straight to the regulator chip. Worked great on mine. 73, Fred AB5AZ |
