| Author |
Message |
    
Kosmic
Junior Member
Username: Kosmic
Post Number: 11
Registered: 7-2006
| | Posted on Tuesday, September 19, 2006 - 1:21 pm: | 
|
I have a problem with a mic, seems it stopped working out of the blue. Changed battery with out fixing the problem. checked alignment of RT switch on board found that to be fine. Checked wiring with all there fine. Placed ground probe in pin 1 and red to slot 2 and find it showing contenuity. Red to slot 3, key mic and showing what it should. Red to 4, key mic and gives me the reading I should have. When I hook it to radio I show a signal yet no modulation. About to pull hair out here!!!!!! What am I missing? |
Unit199
Intermediate Member
Username: Unit199
Post Number: 352
Registered: 8-2003
| | Posted on Tuesday, September 19, 2006 - 8:38 pm: |
|
CHECK ELEMENT, BECAUSE I HAVE HAD THAT HAPPEN BEFORE AND IT SEEMS IT IS THE LAST THING YOU THINK OF.
HARVE
UNIT199 |
Kosmic
Junior Member
Username: Kosmic
Post Number: 12
Registered: 7-2006
| | Posted on Wednesday, September 20, 2006 - 6:52 pm: |
|
Your right being it is basically a new mic that is the last. Will do that next time I have a few minutes to look it over again. |
Bc910
Advanced Member
Username: Bc910
Post Number: 771
Registered: 7-2004
| | Posted on Wednesday, September 20, 2006 - 8:20 pm: |
|
Check the elements connection to the board too, I have had them just plain come off. But you wuld never know 'couse it is connected everywere else so it hasn't moved.
BC |
