| Author |
Message |
    
Bbmfic
Intermediate Member
Username: Bbmfic
Post Number: 121
Registered: 1-2003
| | Posted on Thursday, December 01, 2011 - 3:05 pm: | 
|
i just got a tram d201a it is in very good condition trans. & rec. no mods done to it what is it that has to be done to get the vfo (manual) to work on transmit? & any other mods can be done to it thanks bbmfic |
Funtimebob
Intermediate Member
Username: Funtimebob
Post Number: 334
Registered: 5-2002
| | Posted on Thursday, December 01, 2011 - 3:57 pm: |
|
1) Remove Orange wire from relay and connect to PC board Ground
2) Install jumper from White/Blue wire on relay to White/Orange wire on relay
3) Remove White/Red wire from
D-125, Remove Anode end(no stripe) of D-126 from front wafer switch and connect to White/Red wire that was removed from D-125
4) The channel selector must be on channel 9 when using the VFO. The clarifier will only change the XMIT frequency when in MANUAL position.
Dyslexics of the world UNTIE!
No I'm not a Tech,I just know enough to be a nuisance.
|
Bbmfic
Intermediate Member
Username: Bbmfic
Post Number: 122
Registered: 1-2003
| | Posted on Friday, December 02, 2011 - 8:45 am: |
|
ok that will work thanks does anyone have the tuneup for it (D 201 A) or a copy of the service manual oh this vfo mod is listed for the D 201 is it good for the D 201 A? thanks bbmfic |
Funtimebob
Intermediate Member
Username: Funtimebob
Post Number: 335
Registered: 5-2002
| | Posted on Friday, December 02, 2011 - 1:42 pm: |
|
Yes that mod is supposed to be good for the 201a
http://www.cbtricks.com/radios/tram/d201a/index.htm
Dyslexics of the world UNTIE!
No I'm not a Tech,I just know enough to be a nuisance.
|
