Mrtwenty_nine
New member Username: Mrtwenty_nine
Post Number: 5 Registered: 8-2013
| Posted on Sunday, August 18, 2013 - 3:56 pm: |
|
A while back some had asked how to make the antenna warning light glow when transmitting. Two ways: 1. On the solder side of the board run a jumper wire from w-17 (red) to w-16 (orange). 2. If you have the front of the radio open, connect a short wire from red wire on the board to the orange wire below it. Now when you transmit the light will light. It goes without saying that your wiring may be different in color and you should check with a DVM to be sure.
Mrtwenty_nine
|