Author |
Message |
Delerius
| Posted on Monday, August 12, 2002 - 12:00 am: |
|
Can anyone give any info in doing this mod to the Connex 4800 (EPT690010Z Board)? Thanks in advance... |
Dx431
| Posted on Monday, August 12, 2002 - 1:35 am: |
|
Delerius try this link: http://www.vvm.com/~radiotx/mods.htm Scroll about half way down the page. |
Delerius
| Posted on Monday, August 12, 2002 - 6:54 am: |
|
Thanks Dx431... I must be blind for I had that info already. Anyhow, I have done the AM Modulation Amplifier Improvement and was wondering if anyone has done the NPC mod to this board as well? As of right now, on low power, I have a dead key of 2 and it will swing 20. On the high power side, dead key is about 10 and it will swing a little more than 20. I noticed in the instructions for the NPC mod, volting the finals is not mentioned. Is it not advisable with this board? not needed? |
Dx431
| Posted on Monday, August 12, 2002 - 1:38 pm: |
|
This link may have the info youre lookin for. http://www.radiomods.co.nz/ept6900.html
|
|