| Author |
Message |
    
Kookieman
| | Posted on Monday, November 04, 2002 - 1:32 pm: | 
|
ANY INFORMATION ON MODS FOR GALLAXY44 ON MOD.,PEAK&TUNE, ETC. KOOKIEMAN
Kookieman,
VR-1 = AM/FM S-Meter
VR-4 = AM/FM Squelch Range
VR-5 = FM Deviation
VR-8 = RF Meter
VR-12 = Low Power AM Modulation
VR-13 = AM/FM High Power
VR-14 = High Power AM Modulation
VR-16 = AM/FM Low Power
SUPER-TALK:
1 - Lift leg of R-238. Insert a 1N4745 Zener Diode (a 16 V, 1 W type) band side up.
2 - Solder the Zener diode to the PCB.
3 - Next, solder the resistor lead you lifted from the PCB to the banded end on the Zener diode.
Gives you FULL Modulation Swing at LOW power. and increases RMS watts too.
As with all mods try these at your own risk.
Lon
tech808
|
Therealporkchop
| | Posted on Tuesday, November 05, 2002 - 10:59 pm: |
|
Yeah driver, through that radio in the pond on your way out the gate.......heheee |
Therealporkchop
| | Posted on Saturday, November 09, 2002 - 7:14 pm: |
|
throw, i can't spell |
Weakeststation
| | Posted on Sunday, March 09, 2003 - 4:46 am: |
|
Channel conversion if you don't know it..
a. open up your radio
b. find the small circuit board on the left of the radio.
c. cut the green wire and tape it off.
d.there is an unplugged connector by this board, plug it in
e.near the front of the radio there is a connector marked +10k. reconnect the plug to the board.
f. thats it, you now have frequencys from 25.165-28.755 ..
take care hope this adds to your knowledge on these radois... |
Bronzepony
New member
Username: Bronzepony
Post Number: 1
Registered: 12-2005
| | Posted on Tuesday, December 13, 2005 - 11:46 pm: |
|
TRIED THIS LOOKED LIKE IT WOULD SWING BUT WOULD NOT KEY ANY THING ON HIGH OR LOW |
|
