| Author |
Message |
    
Kc7qpd
| | Posted on Sunday, January 05, 2003 - 2:27 am: | 
|
Well the Cobra 148 NWST with the MMB8719 PLL
can be modified,But with two switches,
1 get two spst switches
2 On the solder side of the board, locate the trace to pin 14, and cut,then solder a 4.7k 1/4 watt resister across the cut trace, next solder
a piece of wire to the trace that still leads
directly to pin 14, then solder another wire to pin 9, then solder the wires to a switch.
3, next solder a wire to pin 10, and solder one wire to a ground on the board, solder these to a
switch also, thats it, do not try to do the final
switch to pin 11 and 12 as you would with the
regular MB8719 mod, this will take out the
PLL, the MMB8719 is different, You will replace PLL if you try.
4 If you want to do the standard 148 mod to the
148 NWST, you will have to replace the MMB8719,
with a MB8719, than its just like its always been.
Just remember, were not suppose to use those extra
freqs, This is just for your information, since I have not seen any good information for the nightwatcher series 148s, have fun. |
Fusebreaker
New member
Username: Fusebreaker
Post Number: 1
Registered: 3-2004
| | Posted on Thursday, March 18, 2004 - 7:15 pm: |
|
what is the frequency chart for this mod will this cover 27415 to 27445? |
Bushwacker5454
New member
Username: Bushwacker5454
Post Number: 2
Registered: 4-2004
| | Posted on Thursday, May 20, 2004 - 2:22 pm: |
|
Is there any other frequencies that or pins that can be jumped on this pll?
With this mod the freqs end at 27.445 and jump to 27.645--- I want 27.555--- I was hoping there was an easy way to do this. Any ideas or new additions to this pll out there? |
Hootyal
Intermediate Member
Username: Hootyal
Post Number: 117
Registered: 9-2002
| | Posted on Thursday, May 20, 2004 - 8:12 pm: |
|
How about the RCI MB8719? Can it be modded like the original or must it be swapped also? |
Nabracho
New member
Username: Nabracho
Post Number: 1
Registered: 12-2012
| | Posted on Monday, December 24, 2012 - 9:05 pm: |
|
does it work for the 148 gtl made in china (mmb8719)? |
|
