| Author |
Message |
    
Kabar
| | Posted on Wednesday, June 04, 2003 - 2:02 pm: | 
|
What is the procedure for frequency conversion on the newer Cherokee CBS500 Base Station radios and the tuneup locations?
These newer versions do not have the jumper location behind the front panel like the older models. |
Tazzmo
| | Posted on Wednesday, June 04, 2003 - 11:30 pm: |
|
Unplug power source.
Remove top cover.
Locate the black shorting block on the rear side of the display PCB. Move the jumper from left to right two pins. Remember to hold the button down for about 5 seconds after power is applied
Plug the power source back in.
Power on the Unit holding down the Channel 9/19 button.
Remember to hold the button down for about 5 seconds after power is applied.
To change bands just press button #1 and the bands are labeled:
A 25.165 - 25.605
B 25.615 - 26.055
C 26.065 - 26.505
D 26.515 - 26.955
E Does not appear: This is normal 40 CB channels (26.965 - 27.405)
F 27.415 - 27.855
G 27.865 - 28.305
H 28.315 - 28.755
I 28.765 - 29.205
J 29.215 - 29.655 |
Astar
New member
Username: Astar
Post Number: 4
Registered: 9-2005
| | Posted on Saturday, February 18, 2006 - 7:04 pm: |
|
I need this info as well. For the newer one not the older ones that have been referred to. |
|
