Author |
Message |
Phatcat980
New member Username: Phatcat980
Post Number: 4 Registered: 2-2004
| Posted on Saturday, September 25, 2004 - 8:27 am: |
|
Is there any mod that you need to do to this amp for 11 meter? |
Tech808
Moderator Username: Tech808
Post Number: 3679 Registered: 8-2002
| Posted on Saturday, September 25, 2004 - 9:13 am: |
|
Phatcat980, If you purchase it from Copper then there is nothing you need to do. Lon Tech808 |
Phatcat980
New member Username: Phatcat980
Post Number: 5 Registered: 2-2004
| Posted on Monday, September 27, 2004 - 7:33 am: |
|
I have purchased this from a private owner and do not know if they bought it from copper. Any help before I use this amp would be appreciated. |
Tech808
Moderator Username: Tech808
Post Number: 3695 Registered: 8-2002
| Posted on Monday, September 27, 2004 - 9:50 am: |
|
Phatcat980, Go to the link below to see diagram and then on the LEFT of the Schematic Right Above R-4 you will see a 4 pin plug marked 1/2/3/4. Short with a Jumper Pins #1 & 2. http://www.rmitaly.com/download/manuals/KL400-manual_rel_301.pdf I would also suggest using No more than a 2 to 2 1/2 watt dead key / drive into it as it is a LOW DRIVE Amplifier. Lon Tech808 |
2ec837
Junior Member Username: 2ec837
Post Number: 48 Registered: 12-2001
| Posted on Monday, September 27, 2004 - 12:52 pm: |
|
I think Phatcat980 is talking the base amplifier.To enable 11 meters you need to remove an IC chip.I think it is labeled IC1. |
Highlander
Advanced Member Username: Highlander
Post Number: 615 Registered: 12-2001
| Posted on Monday, September 27, 2004 - 2:34 pm: |
|
It might be good to know if we are talking about the KL-400 mobile, or the KLV-400 base. |