Author |
Message |
Goat373
Intermediate Member Username: Goat373
Post Number: 214 Registered: 3-2005
| Posted on Sunday, May 07, 2006 - 11:38 pm: |
|
i want to change the channel 9 switch so it switches to channel 19...is this possible??? |
Therealporkchop
Advanced Member Username: Therealporkchop
Post Number: 624 Registered: 11-2002
| Posted on Monday, May 08, 2006 - 11:36 am: |
|
Yeah there is a diode on the channel selector board you can clip. There are a lot of them, and I don't know which one. Or I hope I'm thinking of the right radio. I know you can do it to a 29. |
Goat373
Intermediate Member Username: Goat373
Post Number: 215 Registered: 3-2005
| Posted on Monday, May 08, 2006 - 6:28 pm: |
|
yeah...on the 29 its d32 i just didnt wanna go snipping yet, cuz i know there are many # differances, even if the same parts apply |
Bullfrog13x4
Junior Member Username: Bullfrog13x4
Post Number: 35 Registered: 3-2006
| Posted on Monday, May 08, 2006 - 6:55 pm: |
|
i think you have to move the tap from one pin to another on the pll it has been a while since i have tried this so i am a little rusty on the subject, butt if rou study the schematics from one that does not have the ch19 switch and then one that does you will see what i am talking about, i think if i remember corectly, if you only cut the diode you will only eliminate the ch 9 and open the switch for another use. hope this helps Bullfrog13x4 |