Thread Last Poster Posts Pages Last Post   Closed: New threads not accepted on this page

Author Message   Admin Posted on Tuesday, November 13, 2001 - 12:04 am:        Step 3 Voyage 9000 Modification Disable On Board Automatic Modulation Control With the radio component side up, knobs facing you Look near the center and REAR of PCB Locate resistor R249 (10K ohms) Color Bands are Brown, Black, Orange Un-solder one wire leg of the resistor and lift it out of it's mounting hole. This disables the onboard AMC circuit built into the radio circuit. This does NOT mean that your radio does not have an active AMC circuit. The NPC-RC modification IS a modulation modification circuit in itself . It controls both the positive AND negative audio peaks so they don't clip and distort the waveform while still maintaining a very high level of CLEAN modulation. Next we will Adjust the Driver Transistor Bias current