Copper Talk » Subscriber (Preview) » Tips and Tricks » Galaxay Melaka » 10 Khz Switch « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

307
Posted on Monday, November 26, 2001 - 7:45 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

10 Khz Jump for the Galaxy Melaka:


1)Remove the bottom cover.

2)Locate IC6 , it is an IC that is behind the channel selector on the main board.

3)Solder one wire about 10 inches long to pin 9 of IC6 on the solder side of the main board as shown in Picture #1.

first wire
Picture 1

4)Solder another wire about 10 inches long to pin 16 of IC6 on the solder side of the main board as shown in Picture #2.

second wire
Picture 2

5)Attach a single pole , single-throw switch to the ends of the two wires you just soldered onto IC6 as seen in Picture #3.

switch
Picture 3

6)Mount the switch on the rear of the radio or where ever you like and secure it..

7)Throw the switch one way , you go UP 10 Khz , throw the switch the other way you are on REGULAR CHANNELS.

Have Funů..