The Channel Master Antenna Rotator System is an easy to use, all in one system that will enable the rotation of an outdoor antenna from an indoor control box and a hand-held remote control. The indoor control unit has internal memory which will allow the user to autotune an antenna to rotate to up to 69 pre-programmed positions. The Channel Master Rotator System can be specifically helpful for those who use a single outdoor antenna but are able to receive signals being broadcast from towers in different directions. In addition to TV antenna used, the Channel Master Rotator System is also popular among ham radio operators and hobbyists for miscellaneous uses requiring remote rotation. The motor and control unit is connected via a 3-conductor wire that carries the electrical voltage and control signals from the indoor control unit to the outdoor drive unit. (Rotator wire not included)
Key Features
- 69 Programmable Preset Positions/Channels
- Improved Mechanical Stability
- Enhanced Brake System
- One-piece cast aluminum gray housing
- Heavy duty rotator motor
- Built-in steel thrust bearings
- Easy push tab wire connections
- Included: drive unit, control unit, power cable, and remote control
• Rotation: 1 RPM
• Gear Ratio: 3,200 to 1
• Accepts TV antenna mast: up to 1.75” in diameter (upper mast)
• Power: 120 V AC
• Operating Temperature: -20 Degrees Celsius to + 55 Degrees Celsius
• Rotate Torque: up to 100 lbs
• Driving Torque: up to 1,000 lbs
• Overall Height: 10.25 in
• Lower motor drive housing: 5.5 x 4.5 x 7 in
• Upper mast mount holes: 2.125 in (center to center)
• Lower mast mount holes: 2.25 in (center to center)
• Size (product): 8.5 x 3.75 x 10.25 in
M00-09200