| Author |
Message |
    
Keith391
New member
Username: Keith391
Post Number: 5
Registered: 3-2002
| | Posted on Tuesday, October 23, 2007 - 12:07 pm: | 
|
I have a Magnum Delta Force that works great except for one problem.It receives and transmits,but when transmitting it is transmitting one channel below the channel it's on.
I would appreciate any response.
Thanks,
Keith391@yahoo.com |
Hyperno_1979
Intermediate Member
Username: Hyperno_1979
Post Number: 474
Registered: 12-2005
| | Posted on Friday, November 02, 2007 - 3:45 am: |
|
Keith,
I am more than likely wrong here but i'm sure i remember reading a post on this in here a while back. Wasn't a Delta Force but another radio and they had a similar problem. If you have the time it might pay to search the posts to see if you can come up with the fix. Best wishes champion.
CEFFFCEF
Bob
CEF703/CVC26
269 Hunter Valley
NOT allowed to hold a passport....
|
Tech858
Moderator
Username: Tech858
Post Number: 24
Registered: 10-2007
| | Posted on Friday, November 02, 2007 - 2:30 pm: |
|
Keith
Have you tried to do a reset on the CPU you should find 2 copper pads on circuit on the rear of the front panel most likely labelled RESET remember to switch radio on for 10 seconds then switch it off and disconnect the power before trying the reset , to reset just short out the 2 copper pads then power the radio up again , this might not help but is worth a try .
Hope you get it sorted .
Tech858/Jim
MM0TXO
CEF#858
HAM#230
CVC#116
Wavin' a hand at ya' fae Scotland 
|
