Copper Talk » Ask The Tech » Amplifiers » Mohawk 10 « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Mousetrap
Posted on Wednesday, February 27, 2002 - 10:37 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
I just picked up a Mohawk 10 linear. Would like any info on this linear. It has 2-OA2 tubes, 1-6146 tube, an 2-572-B tubes. I has a burned high voltage cap(small green plastic case)on the board where two red wires fron the transformer attach.This cap was burned so bad I can't get any #'s or other info that I need to replace it.Can anyone help me with this problem? Thanks, Chuck. cads@penn.com
Top of pagePrevious messageNext messageBottom of page Link to this message

307
Posted on Wednesday, February 27, 2002 - 9:26 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
That cap is a 1000PF , 3500 Volt.. The 2-OA2 tubes are actually used as diodes.

307
Top of pagePrevious messageNext messageBottom of page Link to this message

Mousetrap
Posted on Wednesday, February 27, 2002 - 10:48 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
307; THANKS,DO YOU KNOW ANY MORE ABOUT THIS AMP? SUCH AS WHAT POWER OUTPUT TO EXPECT,IS IT A TEN METER AMP,HOW MUCH DRIVE IS REQUIRED,WHERE TO GET SCHEMATICS FOR IT? ONCE AGAIN THANKS FOR THE INFO. "MOUSETRAP"

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: