| Author |
Message |
    
Jose22
| | Posted on Wednesday, September 04, 2002 - 9:00 pm: | 
|
I just got a DX 33 HML. Pluged up and all worked for 30 seconds. Then dead. Only light on was S-Meter. Turned off and then back on and worked for another 20 seconds. Had 15 Watts on high before going out again. Only light on was S-Meter. Thought it might be a voltage regulator???? No number on board. Maybe as 3600-14B???? How do I identify board, AND get part and repair info??? Can you guys tell me where to start??
Thanks |
Tech671
| | Posted on Wednesday, September 04, 2002 - 9:47 pm: |
|
If it is the main regulator (likely) it's the obviuos large regulator sinked to the right wall near the rear (2sb754). |
307
| | Posted on Thursday, September 05, 2002 - 7:28 am: |
|
He is right , common problem..The center leg of the regulator breaks free from the main board...Center left side on solder side of board. It is attached to the chassis.
307 |
Jose22
| | Posted on Monday, September 09, 2002 - 10:43 pm: |
|
Thanks 307/671. It was regulator. Bad solder joint. Looked good but still faulty. Radio Ok but no Modulation on low power. Med and High ok. Any suggestions.
Jose22 |
|
