| Author |
Message |
    
Xlaxx
| | Posted on Tuesday, January 07, 2003 - 12:08 pm: | 
|
Need mic wiring for this rig. Mic has 4 wires: black, red, white, & shield only.
Thanks!
XLAXX |
Tech808
| | Posted on Tuesday, January 07, 2003 - 7:07 pm: |
|
XLAXX,
Should be:
Pin #1 ~ SHIELD
Pin #2 ~ WHITE
Pin #3 ~ BLACK
Pin #4 ~ RED
Hope this helps.
Lon
Tech808 |
Xlaxx
| | Posted on Wednesday, January 08, 2003 - 8:21 am: |
|
Thank you Lon for the quick reply!
XLAXX |
Tech808
| | Posted on Wednesday, January 08, 2003 - 9:38 am: |
|
Xlaxx,
Glad I could be of help.
Lon
Tech808 |
Xlaxx
| | Posted on Tuesday, January 14, 2003 - 11:22 pm: |
|
Hey Lon-
Where can I get a new cable (complete) for this mic? The mic has been changed out so many times that the new wiring is now in the coiled section of the cable.
Thanks
XLAXX |
Tech808
| | Posted on Wednesday, January 15, 2003 - 1:12 am: |
|
Xlaxx,
I cannot find what I am looking for, but if you call Copper ask the order desk for a Replacement Desk Mic Cord and I am sure they will be able to help you.
Or post a note to the "CUSTOMER SERVICE SECTION" and I am sure the Forummaster will be able to help you.
Any New cord will work you will just have to wire both ends for your application.
Let me know how things turn out.
Lon
Tech808 |
Xlaxx
| | Posted on Friday, January 17, 2003 - 1:10 pm: |
|
808-
Thanks for the lead on the cable.
I was able to find one at my local shop,... it is an Astatic 6ft 6wire but I just cut the blue and yellow out. It works great and was pretty easy to wire up.
Another question:
This old gray turner+3 has a loose head on the top too. It is connected and works fine, but was probably dropped at some point before I got it. How can I tighten it up?? I don't dee any screws or adjustments to do this. Maybe it was machined on to the top from the factory??
Any recommendations??
Did you get the package today??
Thanks
XLAXX |
Tech808
| | Posted on Friday, January 17, 2003 - 10:44 pm: |
|
XLAXX,
Package arrived.
On back of Turner Head you will see a small round Disc that should say TURNER unless it is worn off.
Remove it and you will find a screw to tighten.
Try to use a needle or something very small with a sharp point to remove.
This Should help.
Will drop you an email on monday on mic.
Hope this helps.
Lon |
Xlaxx
| | Posted on Friday, January 17, 2003 - 11:16 pm: |
|
808-
Thanks for the recommendations on the Turner+3!!!!!!!!!!!!! It's a really nice mic.
Got some good responses from the Open Forum too.
Got your email,... wrote you back on the D104.
XLAXX |
|
