Author |
Message |
Jake
| Posted on Sunday, August 24, 2003 - 11:45 pm: |
|
when you key the mike their is no wattage output on AM,USB,LSB oh and when you select LSB both meter lights go out and their is no output or audio when PA is used. The radio receives fine on am and ssb. I replaced both finals,the driver and still no output. I would appreciate any and all help |
307
| Posted on Monday, August 25, 2003 - 3:47 pm: |
|
wheeeeeew!!!! This needs serious attention... 307 |
Adshar64
| Posted on Monday, August 25, 2003 - 3:12 pm: |
|
Id be looking at the audio section. Get a service manual if you can and look at voltages around the place. |
Kc0gxz
| Posted on Thursday, August 28, 2003 - 3:50 am: |
|
Jake The first thing I would check is the voltage regulator and/or bridge rectifier in the power supply. Try this.... If you have a volt-ohm meter, ground the negative lead and put the possitive lead on the power wire that goes to the main board from the power supply. See what voltage is there. It should be around 12-14 volts. Then key the radio and check it again. If the voltage drops substantially, then it's definatly the power supply. The way you explained it, sounds to me like a possible power supply problem. But, I could be wrong. There are other possiblities also. Good luck and 73s. Jeff, kc0gxz. |
|