| Author |
Message |
    
Cdc181
| | Posted on Monday, February 16, 2004 - 10:17 pm: | 
|
i know copper use to sell the eagletomahawk 10 meter base now i got one here has good rx but no tx i replaced the am modulator and pre-driver but still no juice to the final or driver bias's is there a dioed there some where that can be causeing this |
Cdc181
New member
Username: Cdc181
Post Number: 3
Registered: 2-2004
| | Posted on Saturday, February 21, 2004 - 6:39 am: |
|
well guess i will havw to leave it on the shelf |
Cdc181
New member
Username: Cdc181
Post Number: 5
Registered: 2-2004
| | Posted on Saturday, January 22, 2005 - 7:05 pm: |
|
DOES ANYONE KNOW WHATS WRONG WITH THIS RADIO |
Ae548
Junior Member
Username: Ae548
Post Number: 16
Registered: 1-2002
| | Posted on Tuesday, April 12, 2005 - 3:31 am: |
|
look at the big yellow resistors behind the mic plug, inside the radio. I'll bet there toasts? |
Bigbob
Senior Member
Username: Bigbob
Post Number: 1825
Registered: 12-2001
| | Posted on Saturday, April 16, 2005 - 10:33 pm: |
|
Maybe the mike is shot,simplest but most over-looked reason.Bigbob |
Cdc181
Junior Member
Username: Cdc181
Post Number: 16
Registered: 2-2004
| | Posted on Monday, May 02, 2005 - 7:24 am: |
|
ok whats the value of the yellow resistors and if the mic was bad how would that cause no volts to the final or driver how would that cause that |
Cdc181
Junior Member
Username: Cdc181
Post Number: 18
Registered: 2-2004
| | Posted on Monday, May 02, 2005 - 8:33 am: |
|
hey ae548 these are green red red gold silver are these special resistors i'm going to wire a mic up and try that i forget if i checked it then i'm going to try the resistors |
Cdc181
Junior Member
Username: Cdc181
Post Number: 19
Registered: 2-2004
| | Posted on Tuesday, May 03, 2005 - 11:39 am: |
|
well try mic and is working now on to check the resistors on the back of the mic jack.Now any of you copper techs have anyother ideas on this the am reg is new.Also what legs on the am reg do i lift to see if i'm getting and voltage to it thats the only other thing i could think of |
