| Author |
Message |
    
Tumbleweed
Junior Member
Username: Tumbleweed
Post Number: 11
Registered: 10-2004
| | Posted on Tuesday, October 26, 2004 - 1:12 am: | 
|
On my CB I ran the hotwire straight to the battery (through a relay) to hopefully reduce interference. I did not, however, run the negative wire to the battery. Should I have done that or would it make any difference? |
Patzerozero
Intermediate Member
Username: Patzerozero
Post Number: 165
Registered: 7-2004
| | Posted on Friday, October 29, 2004 - 6:17 pm: |
|
thru a relay? direct to battery is always best for positive, same for negative, though to a seat mounting bolt will also work. just check to make sure grounds from battery to alt, engine block, and chassis are GOOD. |
Tumbleweed
Junior Member
Username: Tumbleweed
Post Number: 14
Registered: 10-2004
| | Posted on Friday, October 29, 2004 - 7:50 pm: |
|
Thanks. I used a relay so that my CB and scanner both turn on with the ignition switch. That way I don't have to turn them on and off. |
|
