Author |
Message |
Dogfacedsoldier
Junior Member Username: Dogfacedsoldier
Post Number: 10 Registered: 10-2004
| Posted on Sunday, November 21, 2004 - 2:05 am: |
|
yesterday i received my golden eagle worldwide roger beep and tried installing in it my cobra 142GTL...i followed then enclosed install intructions but it wont work i do 1-5 right and 6 says unsolder receive wire (if any) from mic socket and solder to "R" terminal on the board...but radio diagram says there in no recive wire could this be the prob? help is in need. ive installed roger beeps b4 in other radio but this one got me :S help |
Bc910
Intermediate Member Username: Bc910
Post Number: 206 Registered: 7-2004
| Posted on Sunday, November 21, 2004 - 10:07 am: |
|
there is a recieve wire cobra mic wireing Pin1=Shield Pin2=Audio Pin3=Transmit Pin4=Receive BC |
Tech808
Moderator Username: Tech808
Post Number: 4130 Registered: 8-2002
| Posted on Sunday, November 21, 2004 - 10:23 am: |
|
Dogfacedsoldier, On the Cobra 142GTL with a 5 PIN Microphone Plug/Connector your RECEIVE is Microphone PIN #3 PIN #1 ~ AUDIO PIN #2 ~ SHIELD PIN #3 ~ RECEIVE PIN #4 ~ Sw WIRE PIN #5 ~ TRANSMIT Hope this helps. Lon Tech808 CEF808 N9OSN |
Dogfacedsoldier
Junior Member Username: Dogfacedsoldier
Post Number: 11 Registered: 10-2004
| Posted on Sunday, November 21, 2004 - 7:48 pm: |
|
no wire on pin 3 tho and its a 5 pin. theres 3 wires...pin 1 is red 2 is black and 5 is white (looking at plug with notch on top) will try and get pics and post them somewhere. |
Dogfacedsoldier
Junior Member Username: Dogfacedsoldier
Post Number: 12 Registered: 10-2004
| Posted on Sunday, November 21, 2004 - 9:12 pm: |
|
dunno how well u can see but heres a try at it http://community.webshots.com/album/220692277madGbR?980
|
Dindin
Intermediate Member Username: Dindin
Post Number: 446 Registered: 2-2004
| Posted on Monday, November 22, 2004 - 7:26 pm: |
|
DFS,does the radio recieve without the mic plugged in?if so then that part of your instructions can be disregarded.try running a jumper from the rec terminal on the rb board and to the speaker - (neg) terminal in the radio.that might help.from your pics,the mic jack looks like it may have been modified before. |
Dogfacedsoldier
Junior Member Username: Dogfacedsoldier
Post Number: 14 Registered: 10-2004
| Posted on Monday, November 22, 2004 - 10:14 pm: |
|
it does not recevie with mic unpluged. yup the radio has extra channels (25.995MHz-28.00MHz) and from what i can tell it has a modulation mod to it also. ok and to get this right run a jumper from - neg on the speaker to the receive post on the board...?? |
Dogfacedsoldier
Junior Member Username: Dogfacedsoldier
Post Number: 15 Registered: 10-2004
| Posted on Tuesday, November 23, 2004 - 12:19 am: |
|
well that idea was a flop... |