| Author |
Message |
    
Keith
New member
Username: Keith
Post Number: 1
Registered: 4-2005
| | Posted on Friday, April 08, 2005 - 6:01 pm: | 
|
Can anyone tell me what the measurments are for the length of the front and back copper wire for PDL2 Beams? Also what is the distance between the marks that must be placed on the copper wire to line up on the 4 radials? I can't remember how far to spread these marks out to keep everything even when instaling the copper wire on the front and the back of the beam. Thanks for your help. |
Road_warrior
Intermediate Member
Username: Road_warrior
Post Number: 464
Registered: 7-2004
| | Posted on Friday, April 08, 2005 - 10:07 pm: |
|
Keith,
Check your e-mail for info on the PDL-2.
At the top of the e-mail, click on
Ant info it will take you to PDL-2 manual.
JIM/ PA/ CEF 375 |
Airplane1
Intermediate Member
Username: Airplane1
Post Number: 377
Registered: 5-2004
| | Posted on Saturday, April 09, 2005 - 12:40 pm: |
|
Hi Keith,
the distance is starting at one end,
114.5"-229"-343.5"-458" to get all four marks.
Make sure you are not off by more than1/16 of an inch, this is critical.
Hope this helps, and make sure you stretch the wire.
AP |
Airplane1
Intermediate Member
Username: Airplane1
Post Number: 378
Registered: 5-2004
| | Posted on Saturday, April 09, 2005 - 5:03 pm: |
|
oh, I forgot to give the measurement from the holes on radials, measure from one hole in the radial down along the radial across the hub and to other hole , this measurement should be 13ft-6inch.
hope I explained it so you understand.
AP |
