| Author |
Message |
    
Capt205
New member
Username: Capt205
Post Number: 1
Registered: 5-2005
| | Posted on Friday, May 27, 2005 - 3:10 pm: | 
|
How do I get my S-9 to display six digits instead of five on the freq display. |
Bc910
Advanced Member
Username: Bc910
Post Number: 509
Registered: 7-2004
| | Posted on Friday, May 27, 2005 - 10:36 pm: |
|
one of the jumpers needs to be moved
From the factory there is one jumper in the number 4 position (10 meter only) after being modded, most likely the jumpers are in the 1 aqnd 4 positions, simply remove 4 and there ya go!!! Jp4 is the one closest to the pcbx-0335r3a chip.
BC |
Forummaster
Moderator
Username: Forummaster
Post Number: 402
Registered: 11-2001
| | Posted on Friday, May 27, 2005 - 10:36 pm: |
|
Remove the jumper across JP4 on JP102 as shown below.
 |
Bigbob
Senior Member
Username: Bigbob
Post Number: 1942
Registered: 12-2001
| | Posted on Saturday, May 28, 2005 - 7:41 am: |
|
When forummaster speaks, people listen. |
Capt205
New member
Username: Capt205
Post Number: 2
Registered: 5-2005
| | Posted on Saturday, May 28, 2005 - 9:32 am: |
|
There are jumpers across pin 1 and pin 4, still only 5 digit display unless in SSB mode, then all 6. Any suggestions? |
Capt205
New member
Username: Capt205
Post Number: 4
Registered: 5-2005
| | Posted on Saturday, May 28, 2005 - 9:46 am: |
|
Thanks guys, after re reading your instructions, I removed the jumper from pin 4 and had all 6. Thanks from the new guy. |
