| Author |
Message |
    
T_murph
New member
Username: T_murph
Post Number: 1
Registered: 12-2005
| | Posted on Tuesday, December 13, 2005 - 11:32 am: | 
|
im sure this has been asked a million times before, but what do i need to do, if anything, to make a kl 200p work on cb frequencies?
|
Tech808
Moderator
Username: Tech808
Post Number: 8625
Registered: 8-2002
| | Posted on Tuesday, December 13, 2005 - 1:06 pm: |
|
T_murph,
WELCOME TO THE COPPER FORUM!
If you ored your KL-200P from Copper it will arrive ready to use with no midifications.
If you order it from somewhere else then you will need to convert it.
Lon
Tech808
CEF808
N9OSN |
T_murph
New member
Username: T_murph
Post Number: 1
Registered: 12-2005
| | Posted on Tuesday, December 13, 2005 - 3:51 pm: |
|
thanks for the welcome.
what do i need to do to convert it and also will i need to set the dead key donw to only like a watt or something, and how do i do that on a uniden pc 68 xl? this was scanned out of the back of the catalog that i bought it from it says something about removing a chip and i know what chip and can easilt remove it, but is that what i need to do to use it on cb freq.?
|
T_murph
New member
Username: T_murph
Post Number: 1
Registered: 12-2005
| | Posted on Tuesday, December 13, 2005 - 4:53 pm: |
|
also, what would happen if i use the amp on a stock radio? |
Vanillagorilla
Intermediate Member
Username: Vanillagorilla
Post Number: 375
Registered: 4-2005
| | Posted on Tuesday, December 13, 2005 - 5:49 pm: |
|
As for the AMP...I don't know. Go to the RM Italy site and look around...it MAY be good to go as is.. I DON'T KNOW for sure.
As for the radio you must be sure the dead key is at or below 2 watts to be safe. Look to the "Modification List" to the left. Find your radio and adjust the VR for AM power using a reliable watt meter. IF you were to use the radio stock (3.5-4watts?)it might work but NOT for long.
Good luck~
Hank CEF559 |
Road_warrior
Senior Member
Username: Road_warrior
Post Number: 1055
Registered: 7-2004
| | Posted on Tuesday, December 13, 2005 - 7:48 pm: |
|
I have a KL 200P. I use a Texas Ranger TR966.
I run 3 watts dead-key into amp.
JIM/PA/CEF 375 |
