| Author |
Message |
    
Audiophile73
Intermediate Member
Username: Audiophile73
Post Number: 112
Registered: 5-2004
| | Posted on Wednesday, May 10, 2006 - 7:57 pm: | 
|
need to know what goes into a swing kit for this radio. I thinks its causing a problem, I am assuming a diode resistor and cap, but I don't know where the hell to look for one. I need to know what to take out any help would be nice |
Hotwire
Senior Member
Username: Hotwire
Post Number: 1340
Registered: 1-2005
| | Posted on Thursday, May 11, 2006 - 10:58 am: |
|
From the radios I have had in the past that contained swing kits, The resistor is usually installed on the solder side in the left or right corner of the back of the radio. You can detect it sometimes cause it will stick out like a sore thumb. |
Moonraker
Intermediate Member
Username: Moonraker
Post Number: 203
Registered: 3-2005
| | Posted on Thursday, May 11, 2006 - 8:59 pm: |
|
If you find the resistor Hotwire mentioned. It should be on the solder side of the board in front of the final. The resistor will be soldered to the legs of a cap on the other side (component side). Remove the resistor and replace the cap with a jumper. This is how the radio was stock. |
Audiophile73
Intermediate Member
Username: Audiophile73
Post Number: 113
Registered: 5-2004
| | Posted on Tuesday, May 16, 2006 - 2:37 am: |
|
thanks, i will check that out tomorrow and get back to you |
