Copper Talk » Ask The Tech » General Technical Questions » Meter light 88 galaxy « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Moderator1516
Moderator
Username: Moderator1516

Post Number: 213
Registered: 8-2005


Posted on Friday, May 12, 2006 - 7:15 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

could any one tell me how to replace the meter light on my 88 galaxy
moderstor 1516
the skilletlicker
cef 139
cvc 12
ham 147
ki4kxl
Top of pagePrevious messageNext messageBottom of page Link to this message

Therealporkchop
Advanced Member
Username: Therealporkchop

Post Number: 654
Registered: 11-2002


Posted on Friday, May 12, 2006 - 10:33 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Yeap. First go buy a LED and forget using the regular bulbs. Cause all they do is burn out.

Take the top cover off the radio. Look to the side of the meter and you'll see two red wires going into a small little grommet. Pull or pry it out and slide the grommet down the wire. Clip the wires as close to the bulb as possible. Strip the two wires back, put a little solder on them and solder the new bulb onto the wires. Slide the grommet back down over the bulb. Make sure you have no wire exposed outside the grommet. Push it back into the meter.

A word of advice would be to make sure the radio is unplugged. Cause if not and especially if it's on you could have problems.

If you wanna use the LED method, go to the shack and get the color you want. Get a bright one. Remove the knobs on the radio and the faceplate. You'll have to remove the covers also. Lift the meter out of the radio, it easily falls out. Look on the bottom side and you'll see it is open. Once you have the LED in the color you want, get a resistor to drop voltage if it's not designed for 12 volts. Prepare it like the bulb. Insert it into the meter. You might have to do a little pushing or prying depending on the size of the LED. Once it's in place, get some aluminum foil. Make sure the wires aren't exposed and use the foil to make a reflector inside the meter. That will help to keep just one end of the meter lit up. Put a small piece of tape over that hole and re-install everything in the reverse order you removed it.

You should now have a meter light that won't burn out for a long time. It won't get as hot as a bulb and it won't dim down when you key up.
Top of pagePrevious messageNext messageBottom of page Link to this message

Moderator1516
Moderator
Username: Moderator1516

Post Number: 215
Registered: 8-2005


Posted on Saturday, May 13, 2006 - 5:45 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

from the skilletlicker:
thanks a lot for the info therealporkchop
moderator1516
Top of pagePrevious messageNext messageBottom of page Link to this message

Therealporkchop
Advanced Member
Username: Therealporkchop

Post Number: 665
Registered: 11-2002


Posted on Saturday, May 13, 2006 - 6:06 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

No Prob...hope it helps ya.

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: