Hy-Gain CD-45II Rotor

Die cast ring gear, heavy duty, stamped steel gear drive, trouble free gear train. It handles 8.5 sq. feet mounted inside a tower, or 5 sq. ft. with mast adapter. Low temperature grease good to
-30 F degrees. Bell rotator design gives total weather protection, dual 24 ball bearing races gives proven support.
North center scale, dual lighted directional meter indicator, 8-pin plug/socket on control unit, snap-action control switches. Low voltage control. Safe operation, takes masts to 2 1/16". MSLD light duty lower mast support adapter included. Power requirements: 110V 60Hz.

• CD-45II Rotator Specifications
• Wind Load Capacity (inside tower) 8.5 square feet
• Wind Load Capacity (with mast adapter) 5.0 square feet
• Turning Power 600 pounds
• Brake Power 800 pounds
• Brake Construction Disc Brake
• Bearing Assembly Dual race/48 ball bearings
• Mounting Hardware Plate clamps/Steel U-Bolts
• Control Cable Conductors 8
• Effective Moment (in tower) 1200 ft/lbs.

T40-00006

Randy Brumback |
10/25/2008

An excellent rotor with fun to use control box. Maybe not a Ham IV, but not far off. This is one of my most favorite rotors. It is pricey, but you have to pay for quality. I always recommend the use of a bearing plate at the top of a tower to take the load off the rotor and lessen the possibility of indention marks in the cast molding of all rotors. If this rotor is installed properly, it will give you years of pleasure.

Showing 1 to 1 of 1 (1 Pages)

Write a review