Manufacturers
Shop by Brand

XLF 20C 3 Pin Filter Cord

XLF 20C 3 Pin Filter Cord
Brand: RF Limited
Product Code: P03-00004
Discontinued
This product is no longer available!
3 reviews   Rating: 5/5.
Based on 3 reviews   |  Write a review

The XLF-20C? & XLF-20M? look exactly like the original PLF-10C? & PLF-10M?, the differences are in the electrical circuits.
All noise or interference enters a 2-way radio thru the antenna system or the 12 volt DC lines.

The XLF-20C? & XLF-20M? are rated at: 6-16 Volts DC "20" amps continuously, and are known as "COMMONMODE" filters. Unlike the PLF the XLF's address a WIDER range of interference problems and will reduce or eliminate not only DC noisewhich include alternator, turn signals and windshield wipers, it will also cancel any RFI that is coupled into the DC line, and due to it's design there is absolutly no voltage drop thru the filter. In addition the commonmode filter provides the highest isolation to both RF and Noise.

Commonmode filters will reduce or eliminate noises in all 12 volt electronic components, these include 2 way radios, audio systems, including AM/FM receivers, stereos, amplifiers and video components.

The instructions on the backer card now give instructions for a simple test that will determine if the noise/interference is thru the Antenna or DC lines.

PRE-INSTALLATION TEST

All noise or interference comes into your radio either through the antenna system or the DC power lines. The XLF-20C? and XLF-20M? will effectively cancel or reduce the noise coming through the DC power lines. To determine if the noise you are experiencing is coming in through the antenna or DC power line, conduct this simple test:

1. Start the vehicle and listen carefully to your radio's receiver noting all interference and noises. Start and stop the various DC switches and motors in the vehicle (windshield, wipers, turn signals, etc.)

2. Unscrew the antenna from the back of the radio and replace it with a dummy load.

3. Repeat step #1 and compare noise levels.

4. Any noise or interference that remains after the antenna system has been replaced with a dummy load, will be reduced or eliminated by using the XLF-20C? or XLF-20M?.
P03-00004

| 3 reviews
i got the orignal plf . it does great job of filtering out alt. whipers, even other passing cars. recently am using it o my base cause my switching power supply was causing noise on 11m band. after hooking it up i cant notice any noise now so not only good for mobile use but seems to work on a bse setup as well. if having noise problems give these a try
| 3 reviews
i was getting ignition noise on the talkback on my galaxy 959 loud enough that you could hardly hear your voice i installed the 3 pin filter cord now i can adjust my echo. works for me.
| 3 reviews
Really worked, took out all background noise from stop lights and caution lights. Removed all motor background noise from car also helped out lot on the white noise form being around lights from restaurants. For the money you cant get hurt it well worth it

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Captcha



Powered By Iglou Internet Services, Inc.
Copper Electronics, Inc. © 2020