Equipped with excellent multi element ground plane
Protection from static discharges DC-Ground
Made of aluminium alloy 6063 T-832
Type: 5/8 wave ground plane
Frequency range: 26-29 MHz
Impedance: 50 ohm unbalanced
Radiation (H-plane): 360? omnidirectional
Gain: 1.3 dBd, 3.45 dBi
Bandwidth at S.W.R. 2:1: 2100 KHz
S.W.R. at res. freq.: ~1.1:1
1000 Watts (CW) continuous
3000 Watts (CW) short time
Feed system / position: Transformer DC-ground / base
Materials: Aluminium, Copper, Nylon
Wind load / resistance: 166 N at 150 Km/h / 130 Km/h
Wind surface: 0.14 m?
Height (approx.): 240 inches
Weight (approx.): 11.7 lbs.
Radial length (approx.): 27.5 inches
Mounting mast: ? 1.5 - 2 inches
Derek DaKara |
These are great antenna's.I have co/phased these up which really works great too.They hold their value well.We paid this 10 years ago too.They are way better then any fiberglass antenna you can buy on the market.
Rick Ray |
Purchased one and it was easy enough to put together. It came missing the screw for the egg beater so I got one from a hardware store and Immediately started talking skip and getting great comments. Swr was just about flat 1. I just wish it could hold more power but I am totally pleased for the most part. Still barefoot and happy.
dale london |
i got this antenna during the winter and last weekend may2 ,09 i got it up
this antenna once i understood the directions was pretty simlpe to get together
i always had the simple fiberglass antennas and this antenna isnt much if any harder
to assembly.the swrs were a breeze if assembled right using the top whip with the round
egg beater the whip was pre marked on how far to insert whip.simple enough.
swrs on 11 meter are 1.2 on 1 and 1.1 on 40.and only a 1.2 into 10meters.
performance is very close to the imax2000 it replaced recieve is slightly better
less noise.anyone wanting a allumin groundplane i highly reccomend this one